MITSUBISHI ENERFORCE PUMP SSP405S


MITSUBISHI ENERFORCE PUMP SSP405S Stainless Steel Submersible Pump for drainage waste water and effluent.

MITSUBISHI ENERFORCE PUMP SSP405S

FEATURES :

  • High starting-torque motor
  • High-grade stainless steel & engineering plastic for high corrosive resistance and lighter weight compare with cast iron
  • Built – in automatic thermal protector to protect motor from burning even when impeller is being locked
  • Equipped with double mechanical seal, ceramic-carbon and silicon carbide sealing surfaces in food grade oil for KOI friendly.
  • With float switch model, Pump will stop automatically t low water level to protect from motor damage.

SPECIFICATION :

  • Pumping fluid :
    Type of fluid : Drainage waste water and effluent
    pH 5-9
    Temperature : 0 ~ 40 deg. C
  • Pump
    Impeller : Semi Open type
    Shaft seal : Double mechanical seal with oil chamber
  • Pump Material :
    Casing : Fiber – reinforced plastic
    Impeller : Fiber – reinforced plastic
    M. Seal : SiC + SiC + Ceramic / Carbon
  • Motor :
    Type : Dry type Submersible Induction Motor (IP 68) 2P Insulation Class F
    Supply : 1 phase (220 V) and 3 phase (380 V)
    Starting Method : Capacitor Run (Single phase), Direct on Line (Three Phase)
    Protector : Miniature Thermal Protector (Single phase), Circle thermal protector ( three phase)
    Bearing : Double shielded ball type

TECHNICAL DATA MITSUBISHI ENERFORCE PUMP SSP405S

  • Model: SSP-405S
  • Watt: 400 watt
  • Head: 12 meter
  • Capacity : 250 Liter/min
  • Discharge : 2″ (50 mm)
  • Output : 0.4 Kw/0.5 Hp
  • Voltage : 220V/50Hz
  • Pole : 2
  • Speed : 2900 rpm
  • MADE IN THAILAND

Have any Question or Comment?

Leave a Reply

Your email address will not be published. Required fields are marked *

Copy Protected by Chetan's WP-Copyprotect.