MITSUBISHI ENERFORCE SSP 255S Stainless Steel Submersible Pump for drainage waste water and effluent.
FEATURES :
- High starting-torque motor
- High-grade stainless steel & engineering plastic for high corrosive resistance and lighter weight compare with cast iron
- Built – in automatic thermal protector to protect motor from burning even when impeller is being locked
- Equipped with double mechanical seal, ceramic-carbon and silicon carbide sealing surfaces in food grade oil for KOI friendly.
- With float switch model, Pump will stop automatically t low water level to protect from motor damage.
SPECIFICATION :
- Pumping fluid :
Type of fluid : Drainage waste water and effluent
pH 5-9
Temperature : 0 ~ 40 deg. C - Pump
Impeller : Semi Open type
Shaft seal : Double mechanical seal with oil chamber - Pump Material :
Casing : Fiber – reinforced plastic
Impeller : Fiber – reinforced plastic
M. Seal : SiC + SiC + Ceramic / Carbon - Motor :
Type : Dry type Submersible Induction Motor (IP 68) 2P Insulation Class F
Supply : 1 phase (220 V) and 3 phase (380 V)
Starting Method : Capacitor Run (Single phase), Direct on Line (Three Phase)
Protector : Miniature Thermal Protector (Single phase), Circle thermal protector ( three phase)
Bearing : Double shielded ball type
TECHNICAL SPECIFICATION MITSUBISHI ENERFORCE SSP 255S :
- Discharge : 1.5″ (40mm)
- Total Head : 9.0 m
- Flow rate : 180 l/min
- Output : 0.25 Kw / 1/3 Hp
- Voltage : 220V/50Hz
- Pole : 2
- Speed : 2900 rpm
